Zenith ZC800, Owner'S Manual

9

8

Code Identification Feature

The Code Identification Feature allows you to identify
the 4 digit library code stored under your device key.
For example, if you want to find out what 4 digit code is
stored under your TV device key, follow the six steps
below:

1. Press and hold the 

SETUP 

button until the red

indicator stays on. Release the

 SETUP 

button.

2. Press and release the desired mode button (

TV

,

DVD

, etc.). The red indicator blinks, then stays lit.

3. Press and release the 

SETUP 

button. The red

indicator blinks off.

4. To find the first digit for the code stored under the

mode key pressed in step 2, press each numeric key
from 

0-9

 in turn. When the red indicator blinks off

the number you pressed is the first digit for the code
you are searching for.

5. To find the second digit, repeat step 4, this time

when the red indicator blinks off this is the second
digit.

6. Repeat step 4 to find the third and fourth digits.

Code Search by Brand

Lets you search for a code for a specific Brand within
the Code Library for a particular manufacturer.

1. Turn on the device (TV, DVD, etc.) to be controlled.
2. Press and hold the 

SETUP 

button until the red

indicator remains on, then release 

SETUP 

button.

3. Press and quickly release the desired mode button

(

TV

, 

DVD

, etc.). The red indicator blinks off once.

4. Press and release the numeric button (

0-9

)

corresponding to desired Manufacturer (see table on
next page).  The red indicator blinks off once. Note,
pressing “0” performs a full library search same as
normal Code Search Method on previous page.

5. Press the 

CHANNEL UP

 button repeatedly until the

device to be controlled changes channel. The red
indicator blinks off with each button press. If you
accidentally overshoot the code required, press the

CHANNEL DOWN 

button to backtrack through the

library until the device changes channel. Pressing

CHANNEL UP

 changes direction to forward again.

6. Press and release 

MUTE 

to install the code.

Brand Search Method entry is now complete.

Note

: When all codes under a Brand have been searched

the red indicator flashes rapidly for 3 seconds.

Setup, cont.

Setup, cont.

Most users will store DVD codes under the 

DVD 

button,

Cable codes under 

CBL

, etc. If (for example) you want to

store a VCR code under 

CBL

, first follow the procedure

for Direct Code Entry (previous page) and press 

CBL 

in

step 2 of Direct Code Entry, then enter ANY VCR code in
step 3 of Direct Code Entry. Then follow the steps above
for Code Search (or Brand Search, below). 

Note

:  If the

device does not have a

 CHANNEL UP

 button, use

PLAY 

(VCR only) or 

POWER 

instead. Code Search

starts from the currently stored 4 digit number under
that mode.

1

RCA, GE, SA

2

Zenith

3

Philips, Magnavox

4

Sony, Panasonic, Toshiba, Sharp, Pioneer

5

LG, Samsung, Hitachi, JVC, Sanyo

6

Echostar, Sylvania, Dish, Emerson, Fisher, Hughes

0

All