Page 7
TO GET ASSISTANCE, CALL: 919-774-7667
ZENITH PUMPS
WARNINGS:
•
Danger of electrical shock or severe injury. Remove all jewelry prior to working on electri-
cal equipment
•
Ensure electrical power is “OFF” before working inside the equipment
•
Do not remove circuit protective devices, or any other components until power is turned
“OFF”.
NOTE:
Mounting:
•
Ensure the mounting location meets the environ-
mental conditions such as humidity and temperature
(refer to “ZeDrive Standard Specification” on Page
2) for ZeDrive
•
Determine appropriate door or panel location and
make the panel cutout per figure shown at the left
•
Remove (2 ea.) locking cam fasteners from ZeDrive
housing assembly, by removing (2 ea.) screws, one
from each cam fastener (top and bottom)
•
Insert ZeDrive from the panel front and slide it in
until it is flush with the panel surface. Ensure that
supplied gasket is between the drive bezel and
panel surface.
•
Re-install the locking cam fasteners from the rear of
the controller on top and bottom of housing assem-
bly. Rotate the cam fasteners so that ZeDrive pulls
securely against the panel surface.
•
Tighten locking cam fastener (2 ea.) screws (top and
bottom)
Installation
The installation of this motor control must conform to area and local electrical codes. For infor-
mation, refer to the National Electrical Code (NEC) Article 430 published by the National Fire
Protection Association, or the Canadian Electrical Code (CEC). Refer to local codes as applica-
ble.
Zenith
®
Pumps
SET
SPEED
TACH
7
CLEAR
Run
Jog
Preset
Limit Alarm
Dev Alarm
8 9
6
5
4
1
3
2
-
.
0
ENTER
7.5”
3.6”
7.2”
3.9”
5.7”
Zenith
®
Pumps
SET
SPEED
TACH
7
CLEAR
Run
Jog
Preset
Limit Alarm
Dev Alarm
8 9
6
5
4
1
3
2
-
.
0
ENTER
7.25”
±
.03
3.65”
±
.03
Panel Cutout
Summary of Contents for ZeDrive
