Zenith ZN-411, Manual

5

4

Power-On Default

The remote powers on in TV mode.

TV Volume/Mute Punch-Through

The TV Volume/Mute punch-through feature lets you
control the Volume and Mute function of your TV in any
mode programmed to be a VCR, Cable, or DVD device,
without needing to change to TV mode.

VCR Punch-Through

Punch-through to VCR mode is only allowed in TV, and
Cable modes.

Code Setup

The Code Search button is used to setup the remote.
You can either setup the remote using the code for your
brand of product, from the code tables, or you can
search through the library of codes until you find a
code that works for your product.

NOTE: You can store any kind of code under any mode
(except TV). I.E. you can store a VCR code under the
CBL key, or a DVD code under the VCR key, etc.
However, you can only store TV codes under the TV
key.

Code Search.

Battery Installation

1. On the back of the remote,

push down on the tab and
lift the cover off.

2. Match the batteries to the

+ and - marks inside the
battery case, then insert 2
AAA Alkaline batteries.

3. Press the battery cover

back into place.

Battery Saver

Your remote automatically
times out if the buttons are
depressed more than 30
seconds. This will save your
batteries should your remote
get stuck in a place where the
buttons remain depressed
(e.g., between the sofa
cushions).

Code Saver

You will have up to 10 minutes to change the batteries
in your remote without losing codes you have
programmed. However, do not press any buttons until
batteries are installed in the remote. If buttons are
pressed without batteries in the remote, all codes will be
lost.

Setup