Zenith ZN551, Manual

15

14

To Clear all Learned Commands under a mode

1. Press and hold the Code Search button until the indicator light

turns on. Release the Code Search button.

2. Press and release the button for the mode you want to clear

(TV, VCR, etc.). The indicator blinks off.

3. Press and release the Learn button TWICE.  The indicator

blinks off.

4. Press and release Code Search. The indicator blinks off.
All learned Commands under that mode are now cleared.

Master Clear - To Clear all Learned Commands, i.e.
return to factory defaults

1. Press and hold the Code Search button until the indicator light

turns on. Release the Code Search button.

2. Press and release the Learn button TWICE. The indicator

blinks off.

3. Press and release Code Search. The indicator blinks off.
All Learned commands in the remote are now cleared.

1, 4.

2.

3.

1, 3.

2.

Code Learning, cont.

Learning Commands

1. Press and hold the Code Search button until the red indicator

stays on. Release the Code Search button.

2. Press the mode button for the type of device you want to learn

(TV, VCR, Cable, etc.). The indicator lights  blinks off once.

3. Press the Learn button.
4. Press the button on the Learning Remote that you want to

teach, e.g. Power.

5. Point both remotes at each other (see tips on page 11). Press

and hold the Original Remote button that you want to learn,
e.g. Power, until the indicator light turns off.  If there is a
problem with learning, the indicator light blinks for three
seconds but the remote remains in the Learning mode.  If this
happens, repeat from Step 4.

6.. Repeat Steps 4 and 5 for other buttons you want to learn.
7. Press and release the Code Search button when all desired

original remote commands are learned. Code Learning is now
complete.

Note :-  No functions may be stored under the Code Search
button, any mode button, AUX button, or the Learn button.

1.

2.

3.

Approx. 1 inch apart

4.

5.

Code Learning, cont.