Fan Coil ‘Analog’
Technical Support:
4
2
CONFIGURATION
Please note that the screenshots and object names shown next may be slightly different
depending on the device and on the application program.
2.1
CONFIGURATION
After enabling the module, in the general configuration of the device, the "Fan Coil" tab
will be available in the ETS tab tree. In this tab, a box will be provided for each fan coil,
in order to configure them independently. Refer to the specific application program
manual to identify where these boxes are located.
ETS PARAMETERISATION
Figure 1.
Fan Coil - Configuration
Fan Coil X
[
disabled
/enabled
]: enables the “Fan Coil X” tab in the left menu
(see section 2.2).
2.2
FAN COIL X
In this tab, the generic characteristics of the fan coil unit to be controlled are configured.
Among them, the type of fan coil of the installation must be selected:
A
four-pipe
fan coil unit, which requires the simultaneous management of two
independent circuits (one for heating and one for cooling).
A
two-pipe
fan coil unit, which requires the management of a single circuit (for
heating, for cooling or for both).
