DALIBOX Interface 64/32
Technical Support:
49
Initial Status
: sets the desired initial state of the group:
➢
[
Last Value
]: when the KNX bus power is restored, the group will recover
the dimming state previous to the bus failure. Note that this option has no
effect after a download (the group will remain off).
➢
[
Off
]: the group will always start switched off.
➢
[
Defined Value
]: the group will start at a specific dimming level, configured
in
Value
[
0
…100
] [
%
].
Send Status
[
enabled/
disabled
]: if enabled, the status objects will be sent to
the bus at the start-up to inform about the initial state of the group. This requires
that the status objects have been enabled (see section 2.5.5).
➢
Delay
[
0
…255
] [
s
]: sets a delay before performing this sending.
2.5.10
MODES
DALIBOX Interface 64/32 implements two special operation options named as
Burn-in
mode
and
Auto-Off mode
, each of which is explained in detail next.
2.5.10.1
AUTO OFF MODE
The Auto Off mode allows an automatic switch-off of the group if it is found to be steady
(i.e., without receiving further dimming orders) under a certain dimming value
–or
threshold
– for at least a certain amount of time (configurable).
This function will not take place while any of the following is active:
Power supply error.
Short-circuit error.
Test On mode.
Lock.
Burn-in mode.
Timers.
