DALIBOX Broadcast 6CH/4CH
http://www.zennio.com
Soporte técnico:
http://support.zennio.com
31
Figure 16.
Scene configuration
Scene/Sequence Number
: sets the scene/sequence identifying number
(from 1 to 64) whose reception (decreased by 1, according to the KNX
standard) through the “
[Cx] Scenes/Sequences
” object will make the device
trigger the scene/sequence.
Scene/Sequence Type
: selects the action desired for the activation of the
scene/sequence:
“Fixed Value”: the scene activation will consist in setting a fixed dimming
value (0% to 100%) in the channel, according to the following parameters:
•
Value
: sets the desired diming percentage.
•
Dimming Type
: “At Once”, “Dimming Time 1”, “Dimming Time 2”,
“Dimming Time 3”. See section 2.2.1.
In this case it will be also possible to
save scenes
. If a scene saving order
(values 128 to 191) is received, the current dimming level of the channel
will be taken into account for later triggers of the corresponding scene.
“Sequence”: brings the option to define sequences of
up to five steps
,
and to configure the following parameters:
•
Cyclic
: “Enabled” (after the last step, the sequence will start over) or
“Disabled” (default option; in such case, after the last step, it will be
possible to automatically trigger any other sequence parameterised).
•
Next Sequence
: only available if
Cyclic
has been disabled; allows the
execution of another sequence after the last step of the current
sequence. The options are “No Sequence” and “Sequence ‘n’” (being ‘n’
a value between 1 and 10).
