ZENN
iO
AVANCE Y TECNOLOGÍA
www.zennio.com
47
2.4.1.4. RESPONSE DELAY
This parameter sets the time to wait for the object to be sent to the bus
since the action on the input took place. I.e., with a Short Press, for
example, the Z38i panel will wait the established time in "Response Delay
(after Short Press)" before sending the corresponding object to the bus.
To get an immediate sending (no delay), set the value 0 in this field.
2.4.1.5. BLOCK
This parameter uses the object "Block". This object will disable the input.
When receiving a “1” through this object, the InZennio
Z38i will ignore any pulsation on the input.
When receiving a “0” through this object, the input turns
into the “enabled” state again (without taking into
consideration the actions carried out while being
disabled).
2.4.2. SWITCH/SENSOR
A Switch/Sensor connected to an input, consists of an electrical mechanism
which may have its contacts open or closed under normal conditions. These
mechanisms don’t recover their normal position automatically as with the push
button.
A transition of a digital signal from low/high/low is called "Edge".
Falling edge:
Closed contact to Open Contact.
Rising edge:
Open contact to Closed Contact.
Voltage-free contacts of conventional sensors and relays, in general, are
usually configured as switch/sensor input type.
By selecting a Switch/Sensor input, 1 bit “[Switch/Sensor] Edge” communication
object will be sent to the bus every time a rising, falling or both edge (depending
on the parameter selected) is detected.
