KLIC-DA LT
Technical Support:
http://zennioenglish.zendesk.com
6
Red Component (still)
: KLIC-DA is under the programming mode.
Red Component (blinking)
: KLIC-DA is under the safe mode.
Green Component (still)
: KLIC-DA is not connected to the Altherma
system, or the latter is disconnected from the power supply.
Green Component (blinking)
: transmission or data from the P1/P2 bus
towards KLIC-DA.
Blue Component (blinking)
: transmission or data from KLIC-DA towards
the P1/P2 bus.
Note
:
each colour component works with independence of the others.
Therefore, if for instance KLIC-DA is under the programming mode being the
Altherma system disconnected, the effective colour will be orange (still), as
the red and green components will be lighting (still)
.
Input Terminal for the Two-Wire Communication Cable (4)
: slot for the
connection of the two-wire communication cable that will connect KLIC-DA to
the Altherma P1/P2 bus.
Figure 3.
Connection to the P1/P2 bus
1.1.1 and shown in Figure 3, KLIC-DA needs to be installed in
substitution of the original additional user control, while the main user control
needs to be configured as “
At Unit
” under “
User Interface Location
”.
For detailed information about the technical features of KLIC-DA, as well as on security
and installation procedures, please refer to the device
Datasheet
, bundled within the
original packaging of the device and also available at
A. Hydrobox Unit.
B. Main User Interface.
C. KLIC-DA.
