KLIC-DD3
http://www.zennio.com
Technical Support:
http://support.zennio.com
25
Horizontal Flaps
:
“No change”, “Swing Off” or “Swing On” (if this kind of
flaps is available, on the contrary thi
s section will appear as “Not
Available”).
Vertical Flaps
:
“No change”, “Swing Off” or “Swing On” (if this kind of flaps
is available, on the contrary this section will appear as “Not Available”).
Humidifying Unit:
If the humidifying unit is not enabled in AC gateway
configuration, this section will appear as “Not Available”. If the humidifying
unit is enabled, this section only can be configured if in the scene
configuration a humidity compatible mode has been set previously (that is,
Heating, Cooling or Dry mode). On the contrary, this section will appear as
“Not Available (mode)”. If a compatible mode is selected in the scene, a
humidity operation point can be configured using the values: “No change”,
“Off”, “Low”, “Standard”, “High” o “Continuous”.
Notes
:
This parameter is only available if the humidifying unit is enabled in the
A/C gateway configuration (see section 2.4.1) and a Mode allowing
humidity control has been selected in the parameter above (Heating,
Cooling or Dry mode). Otherwise this parameter will be disabled indicating
“Not Available” or “Not Available (mode)”, respectively.
If Dry mode is established in the scene configuration,
“Last (Before
Restart)
” and “Off” options will not be available. This fact is due to Dry
mode involves a humidity control, so it is not possible to establish off
humidity control.
Setpoint
:
“No change” or any value between 10ºC and 32ºC.
2.4.4
ERROR HANDLING
KLIC-DD3 is capable of managing two error types:
Communication or internal errors
: errors in the communication process
between KLIC-DD3 and the A/C unit:
