KLIC-FJ vT
Technical Support:
12
CONTROL CONFIGURATION
Control configuration
: the A/C unit can be controlled only with KLIC-FJ vT or
simultaneously using the remote wire controller. Due to this fact, there are two
options to configure KLIC-FJ vT:
➢
“Autoconfiguration”: KLIC-FJ vT will self-configure as master or slave
depending on whether there is an additional wired remote controller
connected to the A/C unit or not.
➢
“Choose the Number of controllers”
:
allows selecting if there are 1 or 2
controllers in the installation. When selecting this option, the parameter
Number of Controllers
shows up, with the following options:
•
“1 Controller (KLIC as Master)”: KLIC-FJ vT will be configured as a
master.
•
2 Controllers (KLIC as Slave): KLIC-FJ vT will be configured as a slave;
therefore, the wired remote controller will assume master role.
Important
:
the next installation process must be followed in order to have a proper
behaviour (especially if an additional remote wired controller is used):
1. Disconnect installation power supply.
2. Connect the controllers to the installation (application program must be
previously downloaded in KLIC-FJ
vT).
3. Connect installation power supply.
Figure 6. A/C Gateway. Configuration. Control configuration.
