KLIC-FJ vT
Technical Support:
23
ETS PARAMETRISATION
After selecting “Custom” for the
Initial Configuration
option under the Configuration tab
(see section 2.4.1), a new tab named
Initial Configuration
is displayed with the
following parameters:
Figure 18. A/C Gateway. Initial Configuration.
On/Off
:
“Last” (the state the machine had before the power failure), “On” or “Off”.
Mode
:
“Last”, “Automatic”, “Heating”, “Cooling”, “Fan” or “Dry”.
Fan speed
:
“Last”, “Automatic” or any of the available fan speeds (1-4).
Horizontal flaps
: if set, it can be selected
“Last”, “Swing” (if available), “Auto” (if
the automatic flap position control is available) or any of the available flap
positions (1-5).
Vertical flaps
: if set, it can be selected
“Last”, “Swing” (if available), “Auto” (if the
automatic flap position control is available) or any of the available flap positions
(1-5).
Setpoint
:
“Last” or any value between 10ºC and 32ºC.
Note
:
this initial setpoint value may be modified by the setpoint limits during
runtime.
On the other hand, the status objects can be sent to the KNX bus when applying the
initial settings:
