KLIC-FJ vT
Technical Support:
5
Figure 2. Connecting KLIC-FJ vT to the A/C unit.
Important
:
if intending to control the A/C unit both through its incorporated wired remote
control and through KLIC-FJ vT, it must be taken into account the master-slave
configuration assigned to both of them.
For detailed information about the technical features of KLIC-FJ vT, as well as on security
and installation procedures, please refer to the device
Datasheet
, bundled in the device
packaging and also available at
1.3
START-UP AND POWER LOSS
Depending on the configuration, some specific actions will be performed during the
device start-up. The integrator may set up an initial status to be sent to the A/C unit after
the bus power recovery, and whether certain objects should be sent to the bus after the
power recovery, as described in later sections.
On the other hand, when a bus power failure takes place, the device will interrupt any
pending actions, and will save its state so it can be recovered once the power supply is
restored.
AC equipment
Remote (optional)
