KLIC-MITT v2
Technical Support:
6
Figure 2.
Connecting KLIC-MITT v2 to the A/C unit
Important
:
if intending to control the A/C unit both through its incorporated wired
remote control and through KLIC-MITT v2, it must be taken into account that orders
sent from the wired control will have a higher priority than those sent through KLIC-
MITT v2. In addition, certain parameterisations made in the device can be ignored.
For detailed information about the technical features of KLIC-MITT v2, as well as on
security and installation procedures, please refer to the device
Datasheet
, bundled in
the device packaging and also available at
START-UP AND POWER LOSS
Depending on the configuration, some specific actions will be performed during the
device start-up. The integrator may set up an initial status to be sent to the A/C unit
after the bus power recovery, and whether certain objects should be sent to the bus
after the power recovery, as described in later sections.
On the other hand, when a bus power failure takes place, the device will interrupt any
pending actions, and will save its state so it can be recovered once the power supply is
restored.
