KLIC-MITTE
Technical Support:
10
In addition, KLIC-MITTE provides an
error management
function (see section 2.2.33),
which allows sending messages to the KNX bus in case the A/C unit reports any errors.
ETS PARAMETRIZATION
The
“Configuration” tab under Ecodan Gateway provides the following parameters:
Figure 5.
Ecodan Gateway Configuration
UNIT TYPE
Climate Mode Available
[
Heating
/ Cooling/Heating
]. If
“Cooling/Heating” are
selected, the following 1-Bit object will be enabled:
“[Climate] Operation
Mode”
and
“[Climate] Operation Mode (Status)”
. These will allow to
choose under which mode (cold or heat) the unit will operate and to monitor
its status.
Number of Available Zones
[
1
/ 2
]: indicates the number of zones supported
by the unit. Depending on which one it is, the objects corresponding to the
second zone will be displayed. In a generic way, the objects shown by zone
will be:
“[Climate] [Zone X] Temperature Setpoint”:
allows to set the desired
setpoint according to the mode in which the temperature control is
performed.
