KLIC-MITTE
Technical Support:
14
Note:
Initial configuration of the ACS modes will only available if
advanced modes
are enabled in “Configuration” tab
(see section 2.2.1).
Setpoint
[
disabled
/enabled
]:
Value:
Last
: only available if
Setpoint
parameter remains disabled.
40
…60
ºC
: concrete value of the set temperature.
CLIMATE
Operating Mode
[
Last
/ Cooling / Heating
].
Zone 1 / Zone 2
Setpoint
[
disabled
/enabled
]:
Value:
Last
: only available if
Setpoint
parameter remains disabled.
5
…25
…60
ºC
: concrete value of the set temperature. The available
range varies depending on the selected operating mode.
Initial Sending of Status
[
disabled
/enabled
] if this option is enabled, the
corresponding status objects will be sent to the KNX bus with the indicated
delay
[
0
…3600
] [
s
].
Note
:
even if the option to send the initial configuration is not enabled, the
status sending could also take place if the initial stated configured is different
from the one currently available on the machine.
Note:
If “Last” is selected in any of the previous parameters, the same value will be
maintained as it was before its restart.
