KLIC-MITTE
Technical Support:
6
2
CONFIGURATION
GENERAL
After importing the corresponding database in ETS and adding the device into the
topology of the desired project, the configuration process begins by entering the
Parameters tab of the device.
ETS PARAMETERISATION
The
“General” screen is shown in the first place, containing the following parameters:
Figure 3.
General
Ecodan Gateway
[
enabled
]
1
: entails all functions specific to KLIC-MITTE,
relating to communication with the Ecodan unit and management of the
climate and hot water control system. For more information, see section 2.2.
Inputs
[
disabled
/enabled
]: enables or disa
bles the “Inputs” tab in the tree on
the left. For more information, see section 2.3.
Logic Functions
[
disabled
/enabled
]: enables or disables the
“Logic
Functions
” tab in the tree on the left. For more information, see section 2.4.
Heartbeat (Periodic Alive Notification)
[
disabled
/enabled
]: this parameter
lets the integrator incorporate a one-
bit object to the project (“
[Heartbeat]
Object to Send ‘1’
”) that will be sent periodically with value “1” to notify that
the device is still working (
still alive
).
1
The default values of each parameter will be highlighted in blue in this document, as follows:
[
default
/rest of options
].
