KLIC-MITTE
Technical Support:
17
LOGIC FUNCTIONS
This module makes it possible to perform numeric and binary operations with incoming
values received from the KNX bus, and to send the results through other
communication objects specifically enabled for this purpose.
KLIC-MITTE can implement
up to 10 different and independent functions
, each of
them entirely customisable and consisting in
up to 4 consecutive operations each
.
The execution of each function can depend on a configurable
condition
, which will be
evaluated every time the function is
triggered
through specific, parameterisable
communication objects. The result after executing the operations of the function can
also be evaluated according to certain
conditions
and afterwards sent (or not) to the
KNX bus, which can be done every time the function is executed, periodically or only
when the result differs from the last one.
Please refer to the “
Logic Functions
” user manual (available in the KLIC-MITTE
product section at the Zennio homepage,
) for detailed information
about th
e
functionality and the configuration of the related parameters.
