KLIC-MITTE
Technical Support:
8
ECODAN GATEWAY
2.2.1
CONFIGURATION
KLIC-MITTE allows controlling and monitoring an Ecodan unit.
Through the KNX bus, commands to control the following basic functions can be sent
to KLIC-MITTE:
On/Off
switch of the Ecodan unit.
Climate control and supervision:
Climate operation and permission status:
allows to know if the unit is
working and if it is authorised.
Climate mode:
depending on unit characteristics, climate mode can be
changed between heating or cooling. Also, its status can be read.
Machine
climate setpoint temperature
of the available zones. The
temperature can be modified within a range of values according to the
selected
temperature control mode
.
1 or 2
climate zones
can be controlled.
Climate temperature control mode:
using KLIC-MITTE, temperature
control mode can be known (flow temperature, room temperature,
compensation curve), but it only can be changed by wired remote control.
Flow temperature
: this mode allows setting a fluid setpoint for heating
or cooling mode whose ranges will be:
o
Heating
: [25…60] ºC
o
Cooling
: [5…25] ºC
Room Temperature:
allows to establish a temperature setpoint for
heating mode.
o
Heating:
[10…30] ºC
