KLIC-PA
Technical Support:
20
Figure 12. A/C Gateway. Configuration. Filter
•
Filter Objects
[
disabled
/enabled
]: enables 1-Bit objects
“
[AC] Filter (Status)
”
and “
[AC] Filter: Reset
”. “
[AC] Filter (Status)
” will send to the bus KNX the
value “1” to indicate that the filter needs to be cleaned. Once the filter is
cleaned, the alarm has to be reset through
the object “
[AC] Filter: Reset
”
sending the value “0” or “1”.
OPERATING TIME
Figure 13. A/C Gateway. Configuration. Operating time.
The operating time of the A/A machine in hours and/or seconds can be known.
The available parameters in ETS are:
•
Seconds
[
disabled
/enabled
]: enables the 2-Byte object
“[AC] Operating time
(s)
”
. This object can be read and overwritten during executing time.
•
Hours
[
disabled/
enabled
]: enables the 4-Byte object
“[AC] Operating time
(h)
”
. This object can be read and overwritten during executing time.
•
Initial Operation Time
[
Keep current value
/ Set value
]:
➢
“Keep current value”: keep the previous value.
➢
“Set value”: allows establishing an initial operating time value.
•
Periodic Sending
[
0/1…
60
…1440
][
min
] [
0/
1…24
][
h
]: resending period (in
hours) of operating time If set to 0 the periodic send is disabled.
