KLIC-PA
Technical Support:
5
Figure 2. Connecting KLIC-PA to the A/C unit.
Important
:
if intending to control the A/C unit both through its incorporated wired remote
control and through KLIC-PA, it must be taken into account that orders sent from the
wired control will have a higher priority than those sent through KLIC-PA. In addition,
certain parameterisations made in the device can be ignored.
For detailed information about the technical features of KLIC-PA, as well as on security
and installation procedures, please refer to the device
Datasheet
, bundled in the device
packaging and also available at
1.3
START-UP AND POWER LOSS
Depending on the configuration, some specific actions will be performed during the
device start-up. The integrator may set up an initial status to be sent to the A/C unit after
the bus power recovery, and whether certain objects should be sent to the bus after the
power recovery, as described in later sections.
On the other hand, when a bus power failure takes place, the device will interrupt any
pending actions, and will save its state so it can be recovered once the power supply is
restored.
