KLIC-SG vT
Technical Support:
4
1.2
INSTALLATION
KLIC-SG vT connects to the KNX bus via the corresponding built-in terminal (5). Once
the device is provided with power from the KNX bus, both the physical address and the
KLIC-SG vT application program can be downloaded.
This device does not need any external power as it is entirely powered through the KNX
bus.
The remaining elements are described next.
Prog./Test button (2)
: a short press on this button will set the device into the
programming mode, making the associated LED (1) light in red.
Note
:
if this button is held while plugging the device into the KNX bus, the
device will enter into safe mode. The LED will blink in red every 0.5 seconds
Analogue-Digital Inputs (4)
: input ports for the stripped cables of external
elements such as switches, motion detectors, temperature probes, etc.
F3/F4 Communication (3)
: 2-wire communication cable that will connect
KLIC-SG vT to the A/C unit. The other end of the cable, therefore, is intended
to be connected to the F3/F4 connector in the PCB board of the internal unit.
1. Prog./Test LED
2. Prog./Test button
3. 2-wire communication connection with
A/C unit (F3/F4 port).
4. Inputs Conector.
5. KNX Conector.
4
2
5
3
1
Figure 1.
Element scheme.
