KLIC-SG vT
Technical Support:
5
Figure 2.
Connecting KLIC-SG vT to the F3/F4 bus.
Important
:
KLIC-SG vT is not compatible with Samsung wired remote control.
For detailed information about the technical features of KLIC-SG vT, as well as on
security and installation procedures, please refer to the device
Datasheet
, bundled in
the device packaging and also available at
1.3
START-UP AND POWER LOSS
Depending on the configuration, some specific actions will be performed during the
device start-up. The integrator may set up an initial status to be sent to the A/C unit after
the bus power restored, as well as the sending of certain objects to the KNX bus, as
described in later sections.
On the other hand, when a bus power failure takes place, the device will interrupt any
pending actions, and will save its state so it can be recovered once the power supply is
restored.
