KNX USB SC
Technical Support:
6
2
CONFIGURATION
On the
first connection
of the device to the USB port of the PC, it will be necessary to
install the corresponding device driver to the operating system, in order to make ETS
detect it (although it will probably be installed automatically when connecting the USB
to the PC). Two alternate procedures are possible:
Running the standalone driver installer file, or
Importing the device database to ETS, as the driver is provided embedded
into the database, therefore making the installation transparent to the user.
Both can be downloaded from the Zennio website:
, section Products
> System > KNX USB SC.
Once the driver is installed, it will be possible to use and configure the device in ETS or
any other KNX diagnose tool.
