MAXinBOX 24
http://www.zennio.com
Technical Support:
http://support.zennio.com
12
Test On Mode
After entering the Test On mode, it will only be possible to control the outputs through
the on-board pushbuttons. Orders received through communication objects will be
ignored, with independence of the channel or the output they are addressed to.
Depending on whether the output has been parameterized as an individual output or as
part of a shutter channel, the reactions to the button presses will differ.
Individual output
: short or long pressing the button will commute the on-off
state of the relay.
Shutter channel
: pressing the button will make the shutter drive move
upward or downward (depending on the button) until the button is released
again, thus ignoring the position of the shutter and the parameterized times.
Note
:
after leaving the Test On mode, the status objects will recover the
values they had prior to entering Test On. As the device is never aware of the
actual position of the shutter (as the shutter drive does not provide any
feedback), these values may not show the real position. This can be solved
by performing a complete move-up or move-down order, or by calibrating the
shutter position in the Test On mode until it matches the status objects
.
Fan Coil module
: the behaviour is similar to that of the Test Off mode,
although in this case the three fan speeds are supposed available.
Disabled output
: short and long presses will switch the state of the
corresponding relay. In case this consists in closing the relay, then the
remaining relays of its block will open, for safety reasons.
The lock, timer, alarm and scene functions, as well as any other orders received from
the bus, will not affect the outputs while the device is under the Test On mode. Status
objects will not be sent to the bus, either.
Important
:
the device is delivered from factory with all the outputs disabled, and with
both manual modes (Test Off and Test On) enabled
.
