© Zennio Avance y Tecnología S.L. Edition 2 Further information
Page
1
/
2
MAXinBOX 8 Plus
Multi-function actuator with 8 outputs 16A
ZIO-MB8P
Technical Documentation
FEATURES
2 different configurable blocks:
Shutter channels (up to 4).
Individual outputs (up to 8).
2-pipe fan coil control (up to 2 units).
Manual output operation with push button and LED
status indicator.
Suitable for capacitive loads, maximum
140 µF
.
Logical functions included.
Output timing facilities.
Total data saving on power failure
Size 67 x 90 x 79 mm (4.5 DIN units).
DIN rail mounting (EN 50022), through pressure.
No external power supply required other than the bus.
KNX BCU integrated.
Possibility to connect different phases in adjoining outputs.
Compliant with the CE directives (CE-mark on the right side).
Programming/test button
: short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe
mode.
If this button is held for more than 3 seconds, the device enters the test mode.
Programming/Test LED:
programming mode indicator (red). When the device enters into safe mode, it blinks (red) every half second. The manual
mode is indicated by the green color. During the start-up (reset or after KNX bus failure) and if the device is not in safe mode, it starts a blue blinking
sequence.
6
1
4
5
7
3
2
Figure 1.
MAXinBOX 8 Plus
GENERAL SYSTEM SPECIFICATIONS
CONCEPT
DESCRIPTION
Type of device
Electric operation control device
KNX supply
Voltage (typical)
29V DC SELV
Voltage range
21…31V DC
Maximum
consumption
Voltage
mA
mW
29VDC (typical)
5.8
168.2
24VDC
(1)
10
240
Bus connection
Typical bus connector TP1 for rigid cable 0.80mm Ø
External power supply
No
Operation temperature
from 0ºC to +55ºC
Storage temperature
from -20ºC to +70ºC
Operation humidity
5 to 95% RH (no condensation)
Storage humidity
5 to 95% RH (no condensation)
Complementary characteristics
Class B
Protection class
II
Operation type
Continuous operation
Device action type
Type 1
Electrical stress period
Long
Degree of protection
IP20, clean environment
Installation
Independent device to be mounted inside electrical panels with DIN rail (EN
50022)
Response on KNX bus failure
Data saving and relays open if channel configured as shutter.
Response on KNX bus restart
Data recovering and output status change according to programming when
recovering.
Operation indication
Programming LED indicates programming mode (red) and test mode (green).
Output status LED indicators reflect current output state.
Weight
290g
PCB CTI index
175 V
Housing material
PC FR V0 halogen free
(1)
Maximum consumption in the worst case scenario (KNX Fan-In model)
1
. Upper outputs
2
. Lower output screws
3
.Programming/Test LED
4
.KNX connector
5
.Programming/Test button
6
.Output control button
7
.Output status LED indicator
