MAXinBOX FC 0-10V FAN
http://www.zennio.com
Technical Support:
http://support.zennio.com
7
7
1.2
INSTALLATION
MAXinBOX FC 0-10V FAN connects to the KNX bus through the on-board KNX
connector.
Once the device is provided with power from the KNX bus, both the individual address
and the associated application program may be downloaded.
This device does not need any additional external power since it is entirely powered
through the KNX bus.
Figure 1
MAXinBOX FC 0-10V.
The main elements of the device are described next.
Test/Prog. pushbutton (8)
:
a short press on this button sets the device into
the programming mode, making the associated LED (5) light in red.
Note
:
if this button is held while plugging the device into the KNX bus, the
device will enter into safe mode. In such case, the LED will blink in red every
0.5 seconds
.
Outputs (2) and (6)
:
output ports for the insertion of the stripped cables of
the systems being controlled by the actuator (see sections 2.3 and 2.4).
Please secure the connection by means of the on-board screws.
1. Multi-Purpose Inputs.
2. 0-10 VDC Outputs.
3. Output Status LED Indicator.
4. Output Control Button.
5. Prog./Test LED.
6. Binary Outputs.
7. KNX Bus Connector.
8. Prog./Test button.
