QUAD Plus
Technical Support:
6
2.2
INPUTS
QUAD Plus incorporates
four analogue/digital inputs
, each configurable as a:
Binary input
, for the connection of a pushbutton or a switch/sensor.
Temperature probe
, to connect a temperature sensor, either models
ZN1AC-NTC68 S/E/F and SQ-AmbienT from Zennio or NTC probes from
third parties (the latter requires configuring their parameters in ETS).
Motion detector
, to connect a motion detector (models ZN1IO-DETEC-P and
ZN1IO-DETEC-X from Zennio).
Important
:
older models of the Zennio motion detector (e.g., ZN1IO-DETEC
and ZN1IO-DETEC-N) will not work properly with this device
2.2.1
BINARY INPUT
Please refer to the specific user manual “
Binary Inputs
”, available in the QUAD Plus
product section at the Zennio website,
2.2.2
TEMPERATURE PROBE
Please refer to the specific user manual “
Temperature Probe
”, available in the QUAD
Plus product section at the Zennio website,
2.2.3
MOTION DETECTOR
It is possible to connect motion detectors (models
ZN1IO-DETEC-P
and
ZN1IO-
DETEC-X
from Zennio) to the input ports of QUAD Plus. This brings the device with the
possibility of monitoring motion and presence in the room, as well as the light level.
Depending on the detection, different response actions can be parameterised.
Please refer to the “
Motion Detector
” user manual, available under the QUAD Plus
product section at the Zennio website (
), for detailed information about
the functionality and the configuration of the related parameters.
