Tecla XL
Technical Support:
8
The following parameters are shown:
Device Orientation
[
Vertical (Rotated) /
Horizontal (Rotated)
]
1
: enables
horizontal
or
vertical
orientation to be assigned to the device, for easy
identification of the push-buttons during configuration process (ETS will show
a figure with the final distribution of the push-buttons). To prevent inconsistency
in the configuration, please note the following criterium:
Vertical (rotado):
Temperature probe hole
on the right side and the
sensors on the middle.
Horizontal (normal):
Temperature probe
hole on the left of the
bottom side and
sensors on the
middle.
Figure 3.
Orientation.
Buttons
[
enabled
]: read-
only parameter to make it evident that the “Buttons”
tab is always enabled in the tab tree on the left. See section 2.2 for details.
Thermostat
[
disabled
/enabled
]
: enables or disables the “Thermostat” tab in
the tree on the left. See section 2.3 for details.
Heartbeat (Periodic Alive Notification)
[
disabled
/enabled
]: incorporates a
one-
bit object to the project (“
[Heartbeat] Object to Send ‘1’
”) that will be sent
periodically with value “1” to notify that the device is still working (
still alive
).
Figure 4.
Heartbeat.
Note:
the first sending after download or bus failure takes place with a delay of
up to 255 seconds, to prevent bus overload. The following sendings march the
period set.
1
The default values of each parameter will be highlighted in blue in this document, as follows:
[
default
/rest of options].
