Tecla XL
Technical Support:
5
Figure 1.
Schematic diagram.
1.2
INSTALLATION
Figure 1 shows the connection outline of Tecla XL:
Tecla XL is connected to the KNX bus through the built-in terminal (1). An external DC
power supply is not needed.
A short press on the
programming button
(5) will make the device enter the
programming mode. The
programming LED
(4) will then light in red. On the contrary, if
this button is held while the device gets connected to the bus, the device will enter the
safe mode
. In such case, the programming LED will blink in red colour.
For detailed information about the technical features of Tecla XL, as well as on security
and installation procedures, please refer to the device
Datasheet
, bundled within the
device packaging and also available at
1.
KNX connector
2.
Fixing clips.
3.
Temperature probe.
4.
Programming LED.
5.
Programming Button.
6.
Touch area.
7.
Proximity and Luminosity.
3
2
6
5
7
4
1
