Z41 Pro / Lite / COM
http://www.zennio.com
Tecnical Support:
http://support.zennio.com
113
CO2
: determines whether the pop-up window should show the instant value of
the
[Energy x] CO2
object or not.
Cost
: determines whether the pop-up window should show the instant value of
the
[Energy x] Cost
object or not.
When this function is assigned to the box, two 1-bit communication objects will also
be added to the project topology:
[Pn][Bi] Energy Monitor: Request
, which will be sent to the bus (value “1”) to
request the updated value of the measurements. This object must be linked to
the analogous object of the external measurement device.
[Pn][Bi] Energy Monitor: Reset
, which will be sent to the bus (value “1”) to
request a value reset to the external measurement device, so the consumption,
CO
2
and cost variables are re-set to zero. This object must be linked to the
analogous object of the external measurement device.
Finally, back to the pop-up window that shows up when the box is pressed, the
following elements must be highlighted:
Evolution of the Power/Flow object: shows, as a graph, the chronological
evolution of the value of the power or flow object, according to the measurement
type. The horizontal axis will show different time lapses (hours, days, or months),
depending on the selected zoom level.
Instant Value of the Energy, CO
2
and Cost objects: indicator that shows the
current value of the already mentioned energy / volume, CO
2
and cost objects,
provided that the
Energy
Consumption / Volume
,
CO2
and
Cost
checkboxes
have been marked.
Zoom Level: two-button control that lets the user change the time scale, so more
/ less detail is shown in the graph of the evolution of the power / flow object. The
behaviour and the representation of the data are similar to those of the numeric
data log (see epigraph 3.6.2.1.5 in section ).
Validation / Refresh / Reset buttons: permit, respectively, closing the pop-up
window, sending an order to re-set the consumption data (through the already
mentioned reset object) and requesting an updated sending of the consumption
data (through the request object, already mentioned as well). Note that the Reset
button requires a long press to perform this action.
