Z41 Pro / Lite / COM
http://www.zennio.com
Tecnical Support:
http://support.zennio.com
73
3.4
INTERNAL CALL (Z41 COM)
After enabling “
Internal Call n
” in the “Video Intercom” subtab (section 3.2.13.2), a new
tab will be incorporated into the tab tree:
Figura 56
Internal Call. Configuration.
The parameters available are:
Name:
name shown in the contact list (see Figure 143).
ID:
contact identifier. If the contacts are imported via USB, this field corresponds
to the
sipID.
Important
: It must match the
My ID
parameter configured in the "Internal call"
tab of the Z41 COM to which the contact refers (see section 3.2.13.2).
IP Address:
IP Address of the contact
Important
: It must match the IP address in the
“VoIP Calls” tab of the Z41 COM
to which the contact refers (see section 3.2.13).
Different Network:
this option must be enabled when the contact is in a different
network. In this case it is necessary to indicate the gateway in
the “VoIP Calls”
tab (see section 3.2.13).
