Z41 COM + Zennio GetFace IP Configuration Guide
Tecnical Support
6
2
BASIC CONFIGURATION
This section shows the basic configuration required in an installation with a single Z41
COM unit and a single GetFace IP unit.
Note
:
For further information about the parameters please refer to the Z41 COM or
GetFace IP user manuals available at the Zennio website (
2.1
Z41 COM CONFIGURATION
The following aspects must be configured in the ETS configuration (default values in
blue
, modified values in
red
):
1.
In “
MAIN CONFIGURATION
”, tab “
VoIP Calls
”:
1.1. IP Address:
192.168.1.101
(the default value can be left).
1.2. Subnet Mask:
255.255.255.0
1.3. Specify Gateway:
Disabled
. (not necessary if the devices are in the same
network).
1.4. Video Intercom:
Enabled
.
Figure 2
Z41 COM
– VoIP Calls Configuration.
