Z41 Pro / Lite / COM
http://www.zennio.com
Tecnical Support:
http://support.zennio.com
66
This screen contains the following parameters:
Default Ringtone:
allows selecting the sound Z41 COM will emit when a call
from an outdoor unit is received. There are seven different ringtones available.
The ringtone selected in this parameter will be the one applied after downloading,
but it can be modified later from the configuration page.
Outdoor Unit n:
checkbox that enables a new tab with the same name in the left
menu where each video intercom is configured (see section 3.3). The following
objects are also enabled:
➢
“
[VoIP] “Do Not Disturb” Mode
”: 1-bit object to activate or deactivate the
do not disturb mode.
➢
“
[VoIP] Ringtone Volume
”: 1-byte object to change the ringtone volume (0-
100%).
➢
“
[Video Intercom] Ringtone
”: 1-byte object to change the ringtone of a call
made from an external unit. Seven values available: 0 = Ringtone 1; 1 =
Ringtone 2
; … ; 6 = Ringtone 7.
➢
“
[Video Intercom] Synchronization
”: 14-byte object for sharing
information between different Z41 COM linked to the same GetFace IP.
Therefore, this object should be linked to the same group address in each
Z41 COM that require to be synchronized.
Through this object is notified to the bus if a call has been attended, muted,
rejected or if the call log has been consulted (for removing the notification
in case there was a not attended call, see Figure 22).
➢
“
[Video Intercom] Incoming Call
”: 1-bit object which is sent with value ‘1’
when Z41 COM receives a call
from an outdoor unit and with value ‘0’ when
the call ends.
➢
“
[Video Intercom] Play Ringtone
”: when this object receives the value “1”,
the ringtone is reproduced one time.