Square TMD
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
36
case of selecting the latter, an additional parameter (“
Value
”) will be
displayed to enter the desired one-byte value (0 - 255).
Action on Long press
: sets the value to be sent to the bus (through “
[Btn]
[In] Two switches - Long press
”) when the user long-presses the button.
The options are the same as for the short press.
LED illumination control
: analogous to the homonymous parameter for the
“Disabled”, “Binary” and “Hold & Release” functions (see previous pages).
The options in this case are “Regular”, “State dependent” and “Dedicated
object”.
Selecting “State dependent” brings an additional parameter, “
LED
Illumination State Object
”, to make the state of the LED correspond either
to object “
[Btn] [In] Two switches - Short press
” (“Short Press Object”) or to
object “
[Btn] [In] Two switches - Long press
” (“Long Press Object”).
Scene
Figure 33
Individual Button – Scene.
Action
: sets whether the value to be sent to the KNX bus (through “
[General]
Scene: send
”) when the user touches the button will always be a scene run
request (“Run scene”) or –depending on the length of button press– a scene
run or save request (“Run (short press) + Save (3s press) scene”).
Scene number
: number of the scene (1 – 64) to be sent to the bus, both in
the case of the run requests and the save requests.
LED illumination control
: analogous to the homonymous parameter for all
the above functions (see previous pages). The options in this case are
“Regular”, and “Dedicated object”.
Scaling Constant /
Counter Constant /
Float Constant