Square TMD-Display
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
40
to receive values from the bus, not to send them). As explained in 2.3.3, the state-
dependent LED lighting will be determined by the value of this object (LED off at 0%
and on at any other level).
The parameters for this function are:
Step
: defines the dimming step (“100%”, “50%”, “25%”, “12.5%”, “6.25%”,
“3.1%” or “1.5%”) to be sent to the light dimmer with every increase /
decrease order.
Note
:
since dimmers typically do not apply the new light level immediately
(i.e., the step regulation is performed progressively) and since Square TMD-
Display sends an order to interrupt the step dimming once the user releases
the button, it is advisable to configure a step of 100%. This way, the user can
perform any dimming step by simply leaving the button pressed and then
releasing it without needing to make successive button presses
.
Action
: assigns each of the two buttons the order to be sent:
“Left=Off; Right=On”.
“Left=On; Right=Off”.
Note
:
this parameter will remain hidden unless having selected “Every button
pair is configured separately” in Action of the pair buttons (see section
2.3.1)
.
LED illumination control
: analogous to the homonymous parameter for the
“Switch” and “Two Objects (short press / long press)” function (see above).
Shutter
Figure 30
Pair Buttons – Shutter.
