Square TMD-Display
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
51
“Left=1; Right=0”.
Note
:
this parameter will remain hidden unless having selected “Every button
pair is configured separately” in Action of the pair buttons (see section
2.3.1).
Link the control with a box in the display
: sets the area of the display
where to show the indicator of this control, i.e., the current fan speed. The
selected box must be configured with the same data type (see section 2.4 for
details).
Note
:
this parameter is only available for Scaling or Enumeration control
types
.
LED illumination control
: analogous to the homonymous parameter for the
previous functions (see above). The options are “Regular”, “State-
dependent”, “State-dependent (both LEDs)” and “Dedicated Object”.
2.3.4
INDIVIDUAL
Buttons configured to work as individual (separate) controls can be assigned any of the
following control functions from the corresponding
Button IX
tab:
LED indicator
: user presses will not trigger any function although the LED
will turn on or off depending on the values received from the bus.
Switch
: whenever the user touches the button, a binary value will be sent to
the KNX bus. This value is configurable and may be 0 or 1, or alternate with
every touch according to the sequence 1
0
1
…
Under a “
state-dependent
” LED illumination, the LED will remain on/off
according to the current state (on/off) of the object.
Hold & Release
: as soon as the user touches the button, a binary value (“0”
or “1”, configurable) will be sent to the KNX bus. And as long as the user
releases the button, another value (“0” or “1”, also configurable) will be sent
through the same object.
The “
state-dependent
” LED mode is not available for this function.