Square TMD-Display
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
65
Upper area, where the
Indicator
is represented. There are up to four
representation modes, configurable in parameters for each indicator:
Permanent
(always shown),
Temporary
(shown for a moment when the
value changes or after a bus recovery),
Intermittent
(intermittent indicator),
and
Progressive
(the icon is progressively drawn from top to bottom).
The boxes in the screen can be assigned different functions, as described next.
ETS PARAMETERISATION
An independent tab for the parameterisation of the Display is shown in ETS by default.
While all the zones remain disabled, it will only contain a sub-tab named Configuration.
Figure 53
Display – Configuration.
One drop-down list is shown per zone. The options under it are:
Disabled. See section 2.4.2.
Single (one big box). Selecting this option brings a new tab to the tree on the
left (named “
Box X
”, where X depends on the display zone). See section
2.4.3.
Double (two small boxes). Selecting this brings the checkboxes “
Box X1
” and
“
Box X2
” (where X depends on the display zone), which turn each of the two
zones enabled or disabled. Depending on this, up to two new tabs (named
“
Box Xn
”) will be included in the tree on the left. See section 2.4.4.
There is also a checkbox named
Advanced options
, which permit configuring the
border lines and the representation of the indicators.
