G
B
11
Warm up the engine before adjusting the idling speed.
■
CUTTING WORK
• By using the shoulder strap, hang the unit on your
right side. Adjust the strap length so that the cutting
head may become parallel to the ground.
(1) Shoulder strap
• Choose a suitable recommended cutting attachment
according to the object to be cut. Never use other
cutting attachment not approved by ZENOAH.
NOTE
■
STOPPING ENGINE
1. Release the throttle trigger and run the engine for
half a minute.
2. Shift the stop switch to the STOP position.
(1) Stop switch
Except for an emergency, avoid stopping the engine
while pulling the throttle lever.
■
ADJUSTING THROTTLE CABLE
• The normal play is 1 or 2 mm when measured at the
carburetor side end. Readjust with the cable adjuster
as required.
(1) Cable adjuster
■
ADJUSTING IDLING SPEED
1. When the engine tends to stop frequently at idling
mode, turn the adjusting screw clockwise.
2. When the cutting head keeps rotating after releasing
the trigger, turn the adjusting screw counter-
clockwise.
(1) Idle adjusting screw
IMPORTANT
7. Operation
OP7
OP8
OP9
OP6
(1)
OP5
