GB-12
BK3420FL-EZ
6. Set up
Installing the nylon cutter (available as an option)
IMPORTANT
Since the resistance of the nylon cutter is larger than
that of the metal cutter, wrong operation of the nylon
cutter will cause the clutch to overheat, deform and be
damaged. When using the nylon cutter, carefully note
the following.
• Use ZENOAH’s genuine nylon cutter. When using a
commercially-available nylon cutter, make sure that
it is no longer than 10 cm in external shape.
• Make sure that the length of the nylon cord is 17 cm
or shorter.
• Keep the engine rotating at high speed while work-
ing.
1. Install the blade rest plate and the outer holder on
the gear shaft correctly, and stop their whirl with the
accessory L-shaped round rod.
2. Screw the mounting bolt (M7 left-handed) attached
to the nylon cutter into the gear shaft, and tighten it
firmly with a wrench.
[Tightening torque]
14.7 to 19.6 N
•
m (150 to 200 kgf
•
cm)
3. Screw the main body of the nylon cutter into the
mounting bolt while fixing the blade rest plate with
the L-shaped round rod, and tighten the main body
of the nylon cutter firmly by hand.
(1) Main body of the nylon cutter
(2) L-shaped round rod
(3) Gear case
(4) Blade rest plate
(5) Outer holder
(6) Mounting bolt
(7) Nylon cord
NOTE
The bolt, washer, and other parts for mounting the blade
are required when using the metal blade. Keep them
carefully so as not to lose them.
01-BK3420FL-EZ_GB_207＿三.indd 12
12.9.21 1:24:15 PM
