GB-7
BK3420FL-EZ
G
B
from rotating cutting attachment
and hot surfaces.
6. Never touch the muffler, spark
plug, or other metallic parts of
the engine while the engine is in
operation or immediately after
shutting down the engine. Doing
so could result in serious burns
or electrical shock.
■
IF SOMEONE COMES
1. Guard against hazardous situa-
tions at all times. Warn adults to
keep pets and children away
from the area. Be careful if you
are approached. Injury may re-
sult from flying debris.
2. If someone calls out or otherwise
interrupts you while working, al-
ways be sure to turn off the en-
gine before turning around.
■
MAINTENANCE
1. In order to maintain your product
in proper working order, perform
the maintenance and checking
operations described in the
manual at regular intervals.
2. Always be sure to turn off the
engine and disconnect the spark
plug wire before performing any
maintenance or checking proce-
dures.
WARNING
The metallic parts reach high
temperatures immediately after
stopping the engine.
3. When replacing the cutting at-
tachment or any other part, or
when replacing the oil or any
lubricant, always be sure to
use
only ZENOAH products or
products which have been
certified by ZENOAH for use
with the ZENOAH product
.
4. In the event that any part must
be replaced or any maintenance
or repair work not described in
this manual must be performed,
please contact a representative
from the store nearest ZENOAH
authorized servicing dealer for
assistance.
5. Do not use any accessory or at-
tachment other than those bear-
ing the ZENOAH mark and rec-
ommended for the unit.
6. Under no circumstances should
you ever take apart the product
or alter it in any way. Doing so
might result in the product be-
coming damaged during opera-
tion or the product becoming
unable to operate properly.
■
HANDLING FUEL
1. The engine of the ZENOAH
product is designed to run on a
mixed fuel, which contains high-
ly flammable gasoline. Never
store cans of fuel or refill the tank
of the unit in any place where
there is a boiler, stove, wood fire,
electrical sparks, welding sparks,
or any other source of heat or fire
which might ignite the fuel.
2. Never smoke while operating the
unit or refilling its fuel tank.
3. When refilling the tank, always
turn off the engine and allow it to
cool down. Take a careful look
around to make sure that there
are no sparks or open flames
anywhere nearby before refuel-
ing.
4. Wipe spilled fuel completely us-
ing a dry rag if any fuel spillage
occurs during refueling.
5. After refueling, screw the fuel
cap back tightly onto the fuel
tank and then carry the unit to a
spot 3 m or more away from
where it was refueled before
turning on the engine.
■
TRANSPORTATION
1. When hand-carrying the product,
cover over the cutting part if
necessary, lift up the product
and carry it paying attention to
the blade.
2. Never transport the product over
rough roads over long distances
by vehicle without removing all
fuel from the fuel tank. If doing
so, fuel might leak from the tank
during transport.
WARNING
■
CONTROLLING BLADE
THRUST
Blade thrust can cause serious
personal injury. Carefully study
this section. It is important that
5. For safe operation
01-BK3420FL-EZ_GB_207＿三.indd 7
12.9.21 1:24:13 PM
