10
and it would be difficult to gain a clear view of the
working area.
c. During rain storms, during lightning storms, at
times of strong or gale-force winds, or at any
other times when weather conditions might make
it unsafe to use the product.
■
WORKING PLAN
1. You should never use the product when under the
influence of alcohol, when suffering from exhaustion
or lack of sleep, when suffering from drowsiness as
a result of having taken cold medicine or at any
other time when a possibility exists that your
judgment might be impaired or that you might not be
able to operate the product properly and in a safe
manner.
2. When planning your work schedule, allow plenty of
time to rest. Limit the amount of time over which the
product is to be used continuously to somewhere
around 30 ~ 40 minutes per session, and take 10 ~
20 minutes of rest between work sessions. Also try
to keep the total amount of work performed in a
single day under 2 hours or less.
1. If you don’t observe the working time, or working
manner (See “USING THE PRODUCT”),
Repetitive Stress Injury (RSI) could occur.
If you feel discomfort, redness and swelling of
your fingers or any other part of your body, see a
doctor before getting worse.
2. To avoid noise complaints, in general, operate
product between 8 a.m. and 5 p.m. on weekdays
and 9 a.m. to 5 p.m. on weekends.
Check and follow the local regulations as to sound
level and hours of operations for the product.
■
BEFORE STARTING THE ENGINE
1. The area within a perimeter of 15 m (50 ft) of the
person using the product should be considered a
hazardous area into which no one should enter. If
necessary, yellow warning rope, warning signs
should be placed around the perimeter of the area.
When work is to be performed simultaneously by two
or more persons, care should also be taken to
constantly look around or otherwise check for the
presence and locations of other people working so
NOTE
WARNING
5. For safe operation
English
Summary of Contents for CHT2200
