40
8. Maintenance
English
■
Sharpening (MA7)
Always keep the file or sharpener at an angle of 45° to
the blade, and:
• Always grind in the direction of the cutting edge;
• Note: files cut only in one direction; lift the file from
the blade when returning to start a new pass;
• Remove all burr from the edge of the blade with a
slip stone;
• Remove as little material as possible;
• Before refitting the sharpened blades, remove filings
and then apply grease.
Do not try to sharpen a damaged blade: change it or
take it to a Service dealer.
■
REDUCTION GEARBOX
Refill gear housing every 50 working hours.
Use greese pump. Feed greese until it comes out of
the base of blades. (MA8)
■
PROCEDURES TO BE PERFORMED AFTER
EVERY 100 HOURS OF USE
1. Remove the muffler, insert a screwdriver into the
vent, and wipe away any carbon buildup. Wipe away
any carbon buildup on the muffler exhaust vent and
cylinder exhaust port at the same time.
2. Tighten all screws, bolts, and fittings.
3. Check to see if any oil or grease has worked its way
in between the clutch lining and drum, and if it has
wipe it away using oil-free, lead-free gasoline.
1. Oil the blade to prevent rust.
2. Empty the fuel tank and put the cap back on.
3. Remove the spark plug, pour a small amount of oil
into the cylinder.
4. Rotate the crankshaft several times using the
starting rope in order to distribute the oil. Put the
spark plug back in.
5. Wrap the engine with a plastic sheet.
6. Store the trimmer in a dry place, preferably not in
direct contact with the floor and away from heat
sources.
9. Storage
English
MA8
MA9
MA7
Summary of Contents for CHT2200
