GB-3
G
B
EXZ2610DL
SAFETY FIRST
Instructions contained in warnings within this manual marked
with a
symbol concern critical points which must be taken
into consideration to prevent possible serious bodily injury, and
for this reason you are requested to read all such instructions
carefully and follow them without fail.
WARNINGS IN THE MANUAL
WARNING
This mark indicates instructions, which must be followed in or-
der to prevent accidents, which could lead to serious bodily in-
jury or death.
IMPORTANT
This mark indicates instructions, which must be followed, or it
leads to mechanical failure, breakdown, or damage.
NOTE
This mark indicates hints or directions useful in the use of the
product.
Contents
1.
Parts location .................................................. 4
2.
Specifications ................................................. 5
3.
Warning labels on the machine ...................... 6
4.
Symbols on the machine ................................ 6
5.
For safe operation ........................................... 7
6.
Set up ........................................................... 11
7.
Fuel and chain oil ......................................... 16
8.
Operation ...................................................... 17
9.
Maintenance ................................................. 25
10.
Storage ......................................................... 31
11.
Disposal ........................................................ 31
12.
Troubleshooting guide .................................. 31
DESIGNATION
:
MULTI PURPOSE TRIMMER
MANUFACTURER
:
Husqvarna Zenoah Co., Ltd.
MODEL
:
EXZ2610DL
SERIAL NUMBERS DATING
:
2010 and onwards
(The year is cleary stated on the rating plate,
follwed by the serial number)
This declaration conform with :
・
DIRECTIVE
2006/42/EC
(The following standards have been applied: ISO 12100-1,-2, FprEN 15503: 2009)
・
DIRECTIVE
2004/108/EC
(The following standards have been applied: EN 61000-6-1, EN 55012 (CISPR 12: 2005))
・
DIRECTIVE
2000/14/EC
conformity assessment procedure followed ANNEX V
(The following standards have been applied: ISO 11094)
・
DIRECTIVE
2002/88/EC
・
ENISO 11806
: BC-EX only
・
ENISO 11680-1 : PC-EX only
・
ENISO 10517
: LRT-EX only
Date :
29 December 2009
Signature :
Kiyoshi Honda
General Manager, Development Center
Authorised representative :
Husqvarna AB
SE-561 82 Huskvarna, Sweden
Person authorised to compile the technical file :
Bo R Jonsson
SE-561 82 Huskvarna, Sweden
EC DECLARATION OF CONFORMITY
(Applies to Europe only)
The undersigned manufacturer,
Husqvarna Zenoah Co.,Ltd.,
1-9, Minamidai, Kawagoe, Saitama, Japan,
declares under sole responsibility that the following products referred to in this
declaration conform with the requirement of the following COUNCIL’S DIRECTIVE.
The products referred to are :
