English -
54
Repair Instructions
Proceed as follows if new bearings and oil seals
must be fitted:
1
Fit the bearing in the flywheel side of the crank-
case half. Make sure the bering is fitted aligned
with the inside of the crankcase. Drive the
bearing lightly into the crankcase with a plastic
hammer. See figure 71.
2
Use special tool 584 14 05-01 as outligned in fig-
ure 72 to press the bearing into the crankcase.
3
Use the same procedure for the press-fitting of
the bearing on the clutch side. Note! Use special
tool 584 14 05-02 in this case.
4
Apply grease to the sealing surfaces. Press-fit
the oil seals as outlined in figure 73. Special tool
used: 584 14 05-01 (MAG side), 584 14 05-02
(PTO side).
Fig 73
Fig 72
Fig 71
NOTE!
Take care to prevent any dirt and foreign
particles from entering the bearings.
Assembly: bearings & oil seals
Summary of Contents for GZ4350
