39
4. Service Guide
Two stage dry element (Pre- Paper filter)
EBZ80 Series
Loosen the knob bolts then remove the element
(pre- paper filter).
4-30 Element Cleaning
Element and pre-filter rinsing
All Models
●
Rinse the element carefully with warm water diluted
detergent or washing oil.
Confirm that no deformity, damage or
deterioration (if touched, element will
crumble) exists.
If necessary replace it with a new one.
●
After rinsing it, tighten squeeze the element to
remove moisture.
●
For a HB23 series and HBZ26 series element or a
EB70 series and EBZ71/ 80 series pre-filter, dry it
after rinsing and then install it.
Caution for element installation
EB4300/ 6200, EBZ4800, EBZ51 Series
The half-wet urethane element should be moistened
with 2-cycle engine oil, softly squeezed, then installed.
・
・・
・
Excessive oil adhesion will cause filter
clogging.
・
・・
・
Never moisten pre-filter (EB70 series and
EBZ71/80 series) with engine oil.
If engine oil adheres to the filter, the paper
layer will not function.
Two stage dry paper filter cleaning
EB70 Series, EBZ71/ 80 Series
Blow compressed air from inside/outside of the filter
along the filter element's pleats
.
Never beat or hit the filter.
CAUTION
CAUTION
CAUTION
Cover
Pre-filter
Knob Bolts
Case
Paper Filter
Warm water diluted
detergent or washing oil
2-cycle engine oil
