GB-14
LRTZ2600
9. Maintenance
PROCEDURES TO BE PERFORMED AFTER EV-
ERY 100 HOURS OF USE
1. Remove the muffler, insert a screwdriver into the vent,
and wipe away any carbon buildup. Wipe away any
carbon buildup on the muffler exhaust vent and cylin-
der exhaust port at the same time.
2. Tighten all screws, bolts, and fittings.
3. Check to see if any oil or grease has worked its way
in between the clutch lining and drum, and if it has
wipe it away using oil-free, lead-free gasoline.
INTAKE AIR COOLING VENT
WARNING
• Never touch the cylinder, muffler, or spark plugs
with your bare hands immediately after stopping
the engine. The engine can become very hot when
in operation, and doing so could result in severe
burns.
• When checking the machine to make sure that it
is okay before using it, check the area around the
muffler and remove any wood chips or leaves
which have attached themselves to the machine.
Failing to do so could cause the muffler to become
overheated, and that this in turn could cause the
engine to catch on fire. Always make sure that the
muffler is clean and free of wood chips, leaves,
and other waste before use.
• Check the intake air cooling vent and the area
around the cylinder cooling fins after every 25
hours of use for blockage, and remove any waste
which has attached itself to the machine. Note that
it is necessary to remove the engine cover shown
in (A) in order to be able to view the upper part of
the cylinder.
IMPORTANT
• If waste gets stuck and causes blockage around the
intake air cooling vent or between the cylinder fins, it
may cause the engine to overheat, and that in turn
may cause mechanical failure on the part of the ma-
chine.
10. Storage
• Aged fuel is one of major causes of engine starting
failure. Before storing the unit, empty the fuel tank and
run the engine until it uses all the fuel left in the fuel
line and the carburetor. Store the unit indoor taking
necessary measures for rust prevention.
• Oil the blades.
Cylinder
Intake air cooling vent
(A)
11. Disposal
When disposing your machine, fuel or oil for the machine,
be sure to allow your local regulations.
