Installation Caution:
This device must be installed in a horizontal position.
Getting Started
Embedded/Mobile Digital Video Recorder series
T I P
Support 12V/3A-5A or 24V/3A. There are 3 cables of the
Power Input (Yellow, Red and Black). The yellow
one is used for signals, used to connect to the car’s
ignition if MDVR is installed in the car. Engine is on or off
the car by turning the Key. If you test the MDVR in the
lab, you need to make the yellow cable and the red cable
of the power short circuit, so the MDVR will start.
Power
R
equi
rem
ents
MDVR Installation layout
-3-
1.
To reduce risk of fire and electronic shock, do not expose
this appliance to rain or moisture. Do not expose this device
with direct sunshine and keep away from high temperature.
2.
Do not remove cover. No user-serviceable parts inside.
Refer servicing to qualified service personnel.
3.
The information in this getting start was current when
published. The manufacturer reserves the right to revise and
improve its products. All specifications are therefore subject
to change without notice.
4.
This device should be installed in a horizontal position.
hank you for choosing our products. Please read these Instructions
carefully so you will know how to operate your MDVR properly.
After you have finished reading, please keep this document in a safe place
T
for future reference.
T I P
1.
Hitachi Brand 2.5
ͳ
and Seagate mobile anti-vibration
and shock resistance HDD are recommended
2.
Compactable Flash Card:
Kingston Brand is recommended
HDD and
CF card
T I P
N O T E
The GPS antenna MUST be hypaethral (on the roof of the
vehicle), and should be horizontal and airward to make
sure the signal can be received.
GPS
-1-
-2-
