1. Remove filters
2. Remove cover from junction box by
(2) screws to gain access to electrical
wiring.
3. If using a cable lock, pry open the
desired electrical knockout either on
top or back of hood. Feed the wires
through the cable lock. Some local
codes require the use of a cable lock,
check your local codes.
4. If using hood in air recirculating
mode skip steps 4 and 5.
Pry open desired 3-1/4” x 10” ducting
knock-out either on top or back of
hood.
5. Secure 3-1/4” x 10” starting collar
with damper to the duct opening using
(8) M4x8 screws.
Note: starting collar is secured inside
the hood to the left of the motor.
Installation –
Preparing Electrical and Ducting
10
www.zephyronline.com
Summary of Contents for Breeze II
Page 2: ...www zephyronline com...
Page 25: ...www zephyronline com...
