Zephyr Verona ZVO-E30AG, Use, Care And Installation Manual

Features & Controls – 

User Interface

12

www.zephyronline.com

Mesh Filter Clean Indicator 

(always enabled)

 - After 30 hours of fan usage the      Graphic and words “

clean mesh filter

” will illuminate indicating it is time to clean

   the mesh filters. Graphic and words will remain illuminated until reset.
 - 

To reset:

 With hood off, hold the      Button for three seconds, after three seconds the       Graphic and words “

clean mesh      

    filter

” will turn off and the 30 hour timer will reset.

Charcoal Filter Replace Indicator

(disabled by default, must be enabled if recirculating hood)

 - To enable Charcoal Filter Replacement Function:
 

- With hood off, hold       Button and       Button simultaneously for three seconds. The       Graphic will illuminate for  

  three seconds indicating the Charcoal Filter Replacement Function is enabled.

 - To disable Charcoal Filter Replacement Function:
 

- With hood off, hold       Button and       Button simultaneously for three seconds. The        Graphic will be  

   illuminated then turn off indicating the Charcoal Filter Replacement Function is disabled.

 - After 120 hours of fan usage the       Graphic and words “

replace charcoal filter

” will illuminate indicating it is time to  

   replace the charcoal filter. 

Graphic and words will remain illuminated until reset.

 - 

To reset: 

With hood off, hold the       Button for three seconds, after three seconds the        Graphic and words “

replace  

    charcoal filter

” will turn off and the 120 hour timer will reset.

Clean Air Indicator

 - Clean Air is a feature that turns the fan on every 4 hours for 10 minutes to remove stagnant air in the kitchen.
 

- To enable Clean Air Function:

- With hood off, hold the      Button and       Button simultaneously for three seconds. The       Graphic and  

   words “

clean air

” will illuminate and the fan will turn on speed 1 for 10 minutes. After 10 minutes the fan  

   will turn off and the 4 hour timer will begin.

-       Graphic will remain on when Clean Air Function is enabled, even if fan is not on.

- To disable Clean Air Function:

- With hood off, hold the       Button and       Button simultaneously for three seconds until       Graphic  

turns 

off.

 - When the Clean Air Function is enabled the fan will turn on speed 1 for 10 minutes every 4 hours of non fan usage. After 10 
   minutes the fan will turn off and the 4 hour timer will reset.
 - If the user changes the fan speed while the Clean Air Function is in use, the words “

clean air

” will turn off but the      Graphic  

   will remain illuminated. If the user presses the      Button at any time the 4 hour clean air timer will reset.